PFP – Firefilm A6 – Water based – Fireproof intumescent paint – up to 90 min.

Firefilm A6 is an intumescent, water-based, white paint, that is designed to provide passive fire protection for interior or semi-exposed metal structures. Firefilm A6 allows high protection times with low thicknesses and the application of layers of up to […]

Water based intumescent paint

 453,75 (incl. tax)


QtyBrush/roller or spray?Max. surface
1 (25kgl.)Min. consumption brush/roller: m2/lt0m2
1 (25kgl.)Min. consumption spray typical DFT: m2/lt0m2

Description

Firefilm A6 is an intumescent, water-based, white paint, that is designed to provide passive fire protection for interior or semi-exposed metal structures.

Firefilm A6 allows high protection times with low thicknesses and the application of layers of up to 1,000 microns(Airless) when wet, allowing shorter installation times and greater advantages on-site.

It is fire resistant for up to 90 minutesFirefilm A6 is solvent-free and has one of the lowest VOC contents on the market: <0.5 g/l.

APPLICATION:

Firefilm A6 can be applied by airless sprayers or by brush/roller. With both methods the layers should be a maximum of 1000 microns. In order to be able to carry out the application we must first prepare the surface.

To prepare the surface we must check that all the surfaces to be coated are  clean, dry and free of loose materials or materials that may prevent proper adhesion. If there are no such materials, the steel structures should be cleaned by blasting under dry atmospheric conditions, using an appropriately-sized and type of abrasive that has a homogeneous abrasive-particle diameter and is free of moisture and oils. Subsequently, protect the steel with a compatible primer as described in document ETA-20/0032.

Do not apply directly to galvanized surfaces. Use a compatible primer.

The room temperature during application should be above 5°C. The relative humidity should be less than 80%. The surface temperature must be at least 3°C above the dew point temperature.

compatible enamel can be applied if a decorative finish or Y display environment is required. See ETA-20/0032 for compatible finishing enamels.

Additional information

WeightN/A
Packaging

25Kg

Product type

Coating, Lining or PFP

PFP

Market Segment

Commercial & Architectural

Brand

Substrate

Carbon Steel, Primed Steel

Solvent

Water based

Industry

Infrastructural Coatings

ISO 12944 Environment

C2

Productivity - Low (*) to High (*****)

*****

Quality - Low (*) to High (*****)

*****

Surf Prep New Steel

BS, Sa1, Sa2, Sa2.5

End use

Cellulosic fire – interior

Detailed information about PFP – Firefilm A6 – Water based – Fireproof intumescent paint – up to 90 min.

Intended usesCellulosic fire protection of structural steel in buildings in visible areas
Max. DFT1000 µm
Min. DFT200 µm
Theor m2/lt at average DFT1000 g/m2 t m2/lt
Typical DFT500
Drying time (25C)Depending on DFT 2-4h hrs
Drying time (10C)Depending on DFT 3-6h hrs
Min. application temp.10C
ChemistryWater based intumescent paint

Downloads

Product nameDocument nameDocument typeLanguageDownload
PFP – Firefilm A6 – Water based – Fireproof intumescent paint – up to 90 min.PDS Firefilm A6Product Data SheetEnglish Download

Reviews

There are no reviews yet.

Be the first to review “PFP – Firefilm A6 – Water based – Fireproof intumescent paint – up to 90 min.”

Your email address will not be published.